new stuff installed!

[grn95t/a]

well i finally got my dual nozzles and fpss installed for the 150hp shot, as well as the racetronix hotwire kit for my walbro 225 fuel pump. here some pics of the nitrous, forgot to take pics of the hotwire kit.

http://i121.photobucket.com/albums/o205/grn95ta/nitrous013.jpg




http://i121.photobucket.com/albums/o205/grn95ta/nitrous014.jpg




http://i121.photobucket.com/albums/o205/grn95ta/nitrous015.jpg




http://i121.photobucket.com/albums/o205/grn95ta/nitrous007.jpg

[Profit Of Doom]

looks good..... nice clean install

[ujokin2]

Hey how come ZEX is showing backwards ? Like I said I am staying in front of you LOL

[grn95t/a]

looks good..... nice clean install

THANKS!

[grn95t/a]

Hey how come ZEX is showing backwards ? Like I said I am staying in front of you LOL


the retard in the assy line was drunk that day! i hope you do, or the juice may get thick on your windscreen! lmao!

[Lt1junkie]

Can't wait to see that thing on the street!!!! BEASTN0S1

[grn95t/a]

i hope so man! i need to get the a/f gauge installed first though, but ran into an isuue with where to put the sensor. theres no room in the i pipe just after the y pipe until where it goes over the axle. not sure if this is to far down stream for an accurate reading? or if i should just put it in the y on one side?

[edcmat-l1]

Lookin good guys. Cant wait to see it run!!!

[socalmach]

Very nice

[grn95t/a]

thanks don! how'd the gears go?

[socalmach]

Couldn't get the C-clips out. Not even with a magnet.

[grn95t/a]

been there before! pia for sure.

[novajoe]

a PLASMA wrinch will take them out! LOL

[Jazz]

hey dude, mine were pretty stuck, did they finally come out?

[slow-v6]

****.. I am going to have to do some more **** to my car just to be able to keep up with you LT1 cars!! Looks good.. Good luck with it, and I hope not to run into you anytime soon!!